Erskine Attachments 420855, Руководство оператора

Страница: 16 / 32

16
Gearbox Oil Check and Fill
Add 80W-90 EP or 85W-140 EP gear lube to gearbox
as needed. Oil capacity is approximately 96 oz.
To check the oil level, lower the cutting wheel so that
the parking stand rests on the ground. Remove the
level check plug [A]. Oil must be level with the check
plug hole. To add oil, remove the fill plug [B] and add
lube until it starts to come out of the check plug hole.
Reinstall the check plug and the fill plug.
Oil should be changed after the first 50 hours of
operation, and yearly thereafter. To drain the oil from
the gearbox, remove the drain plug [C] on the bottom
side of the gearbox.
IMPORTANT: Fluids such as engine oil, gear lube,
and hydraulic fluid must be disposed of in an
environmentally safe manner. Some regulations
require that certain spills and leaks be cleaned in a
specific manner. Check local, state, and federal
regulations for correct disposal methods.
Slip Clutch Adjustment
Slip clutch may be hot. Allow
clutch to cool before servicing.
The slip clutch is factory preset to the correct torque
for protecting the attachment and tractor. For
adjustment, use the following steps.
1. Measure the length of all springs, then loosen all
(8) clutch bolts to remove all tension from the
springs.
2. Hold the clutch hub solid and turn the shaft to
make sure the clutch slips. If the clutch does not
slip, disassemble the clutch and clean with a
clutch cleaning solution.
3. Reassemble the clutch once cleaned.
4. Tighten each of the (8) bolts until the springs are
all evenly compressed to the original length.
ROUTINE MAINTENANCE
IMPORTANT: If the clutch continues to slip
excessively when the springs are compressed
to original length, check the friction discs for
excessive wear. Discs are 1/8” thick when
new. Replace discs after there is 1/16” wear.
A
B
C