Multi Service Edge Device HL950
Administrator’s Guide
Page 145 (159)
EN/LZT 108 5995 R3
June
2003
If this device is malfunctioning, it may also be causing harm to the telephone network; this device
should be disconnected until the source of the problem can be determined and until repair has been
made. If this is not done, the telephone company may temporarily disconnect service.
The telephone company may make changes in its technical operations and procedures; if such changes
affect the compatibility or use of this device, the telephone company is required to give adequate
notice of the changes. You will be advised of your right to file a complaint with the FCC.
If the telephone company requests information on what equipment is connected to their lines, inform
them of:
!
The telephone number to which this unit is connected.
!
The USOC jack required.
!
The FCC Registration Number (indicated on the label).
The Ringer Equivalence Number (REN). Note that if several devices are connected on the same line,
the RENs must not add up to more than 5.0. This REN figure is important to your telco and can be
found on the equipment’s FCC compliance label.
In case of operational problems, disconnect your unit by removing the modular or multi-connector
plug from the telco’s jack. If your regular phone still works properly, your modem has a problem and
must remain disconnected and (officially) serviced or returned for repairs. If upon the above
disconnection your regular phone still has problems, notify your telco that they may have a problem. If
problem is still found in premises wiring not telco-installed, you are subject to a service charge. If a
fault is found in telco-installed wiring, you may still be subject to a service call charge.
Unless otherwise is noted in the User’s Manual (e.g. fuses, etc), user may not under any circumstances
(in or out of warranty) attempt any service adjustment, or repairs on this unit. It must be returned to
the factory or authorized U.S. service agency for all such work. Locations and phone number of
factory or authorized U.S. service points are as following:
Company: ASKEY International Corp.
Address: 1751 Yeager Ave, La Verne, CA 91750, USA
Tel: 909-596-5180
9.4.5 Caution
Changes or modifications to this product not authorized by the manufacturer could void your authority
to operate the equipment and invalidate CE and FCC approvals. The appliance coupler serves as the
mains power disconnect and should be located so it is readily accessible.
9.4.6 Environmental
Information
Maximum environmental values during use:
!
Temperature: 0
o
C to +40
o
C
!
Humidity: 5% to 85% RH, non-condensing.
9.4.7 Intended
Use
For indoor and public use.
WARNING:
This is a class A product. In a domestic environment this product may cause radio interference in
which case the user may be required to take adequate measures.
