Epson Stylus Pro 7450, Руководство пользователя

Страница: 215 / 373

Paper Handling 215
Sensor light
Switches
Adjusting the sensor
The angle of the sensors has already been adjusted when the unit
is shipped. But, if the
Sensor light on the control box is flashing,
you need to adjust the sensor so that the light detector is aligned
with the light emitter. When they are aligned, the
Sensor light
comes on.
c
Caution:
❏
Avoid placing the sensor in direct sunlight; otherwise, the
auto take-up reel unit may not operate properly.
❏
Prevent fans or air conditioners from blowing directly on the
roll paper. If the paper is blown out of the sensor area, it will
not be taken up properly.
To adjust the sensor position, follow the steps below.
ON Indicates that the light detector is aligned with the light
emitter. This means that the Auto Take-up Reel Unit is ready
to wind your printout.
Flashing Indicates that the light detector and light emitter are not
aligned properly. See “Adjusting the sensor” on page 215
for details.
Flashing
rapidly Indicates that the Auto Take-up Reel Unit has
encountered a problem and stopped operation.
OFF Indicates that the Auto Take-up Reel Unit is off.
Auto For automatic take-up of roll paper when roll paper feeds
into the sensor unit’s detection area
Manual For manual control of the take-up of roll paper