Epson PhotoPC600, Руководство по обслуживанию, Страница: 55 / 116

PhotoPC 600
Chapter4 Disassembly and Assembly
Rev. A 4-6
4.1.4.3 Removing CA1 Board, CA2 Board, LCD and CCD
The figure below shows disassembly of CA1, CA2 boards, Lens viewfinder, LCD and CCD.
ADJUSTMENT
n
n n
n
When replacing CA1 Board or CCD, perform the following
adjustments, referring to Chapter 5; 1)Initialization, 2)5100K AWB
adjustment, and 3)Flange-back adjustment.
n
n n
n
When replacing CA2 Board or LCD, perform the following
adjustments, referring to Chapter 5; 1)Initialization, 2)5100K AWB
adjustment, and 3)Flange-back adjustment, 4)LCD H AFC adjustment,
5)LCD RGB Off set adjustment, 6)LCD Gain adjustment, 7)LCD Blue
Brightness adjustment, and 8)LCD Red Brightness adjustment.
CHECK POINT
ü
ü ü
ü
n
n n
n
When assembling the optical filter, Refer to section 4.1.5 “Procedure
for Assembly, since it has a determined direction to be installed.
CCD
7. Remove the Lens-
viewfinder.
5. Remove the Holder
chassis.
6. Screw 2x5
(#100)
8. Screw 2x5
(#100)
9. Screw 2x4
(#102)
12. Remove FPC
from CA2 Board.
4. Screw 2x5
(#100)
3. Screw 2x5
(#100)
2. Screw 2x6
(#104)
1. Screw 2x4
(#103)
10. Remove a connector
from CA2 Board.
14. Remove LCD from the
holder.
Optical filter
11. Release the lock
of FPC connector.
Dampter
13. Release 2 at one side
out of 4 hooks.
Figure 4-6. Procedure for Disassembly (3)