EOS 94 6505 00, Инструкции по установке для ритейлеров

Страница: 65 / 72

EmoTouch 3 - Installation Instructions 65
Installing multiple cabins
3
Plug the relay box for cabin 2 into jack #2 on the relay box for cabin 1.

EmoTouch 3 automatically switches to multi-cabin mode. On the
display, the new cabin in grey is displayed until the cabin address has
been programmed.

The cabin address can be programmed once all lines have been
plugged in, see

Programming addresses,

65.
4
Plug the relay box for cabin 3 into jack #2 on the control panel.
5
Plug the relay box for cabin 4 into jack #2 on the relay box for cabin 3.
6
Plug the relay box for cabin 5 into jack #3 on the control panel.
7
Plug the relay box for cabin 6 into jack #2 on the relay box for cabin 5.
8
Plug the relay box for cabin 7 into jack #4 on the control panel.
9
Plug the relay box for cabin 8 into jack #2 on the relay box for cabin 7.

Once all lines have been plugged in, the cabin addresses must be de-
programmed.

Programming addresses
1
NOTICE You must follow the correct connection sequence in the
EmoTouch 3 control panel.
If the cabin address does not match the connection, the cabin is not de-
tected.
2
Press and hold the programming button on the circuit board of relay
box 2 for approx. 5–6 seconds until the red LED illuminates.

Programming mode is then active. The green LED light goes off.
3
Briefly but firmly press the programming button once.