Entrematic Canada Inc.
Toll Free: 1-877-348-6837
[email protected]
www.ditecentrematic.ca
Entrematic USA Inc.
Toll Free: 1-866-901-4284
[email protected]
www.ditecentrematic.us
Pg. 13
HA8-LP Manual V. 4.0
VERTICAL SECTION
FILLER PLATE
AS REQUIRED,
BY OTHERS
REINFORCEMENT
BY OTHERS
5 1/8 in
[130mm]
HA8-LP
OPERATOR
& HEADER
3 7/8 in
[98mm]
FLUSH
5
Add additional screws to fasten the header back plate to the door frame approximately
12” to 16” apart.
The header must support 200 lbs.
6
When installing a support plate for the full width of the door frame, fasten an additional two (2) screws to the vertical
jambs on the strike side of the door.
7
Install the Spindle into the motor/gearbox.
8
•
Once the header back plate is in place, install the motor/gearbox and control board to the header back plate
(see Section 3.0).
•
Slide the nuts (supplied with the operator) to hold the motor/gear box and control board along the 2 parallel tracks
on the back plate.
•
Fasten the bolt to hold the motor/gear box and control board. The motor/gearbox needs to be installed so that the
center of the spindl
e is 5” (127mm) from the end plate
2.0 OPERATOR INSTALLATION
4 1/8 in
[1
02
mm]