ENFORCER Outdoor Stand-Alone/Wiegand Keypad with Proximity Reader
SECO-LARM U.S.A., Inc.
11
User codes may be assigned to User IDs between 0 and 997.
Do not
use this method for adding a user
code to an existing card user.
Programming User Codes Individually:
When programming user codes, use the following general formula after entering base programming
mode (see "Enter and Exit Base Programming Mode," pg. 7):
– After a short beep, you may continue to add users by repeating
these steps, but without repeating the function code .
– Add Users function code (a short beep will sound and the LED will change to steady orange)
– to
– 997 unique User IDs to trigger the device (if
is omitted, the device will
assign the user code to the first available User ID)
– User code – 4~6 digits (do not use the user code 8888)
With the Master Add Card:
The Master Add Card allows you to enter codes quickly without entering programming mode. It takes
you directly into the "add user" function mode without needing to enter the master programming code
and the add user function code. Once in this mode, you made add codes using the methods
described above, but omitting the . When complete, present the Master Add Card again to return to
standby mode.
NOTES:
It is important to record each User ID assigned in order to simplify future user management.
A user ID can only have a single card or single code assigned (except by using the method
described in "Changing the User Code for an Existing User," on pg. 12 when in the "card+code"
security level). If you try to add a user code to an existing user ID that already has a user card
assigned, the user card will be removed.
Programming User Codes:
Programming User Proximity Cards (Continued):
Additional users may be entered in succession without repeating the function code .
The key returns you to base programming mode (the LED will flash red). Exit programming mode
by pressing the key (see "Enter and Exit Base Programming Mode," pg. 7).
Examples:
1.
Program user card for User ID #0:
Read Card
2.
Program a user card allowing the device to auto-assign to the first available User ID (not
recommended unless you have a complete record of already assigned User IDs):
Read Card
3.
Program a batch of 50 cards, starting with card# 23456789 and beginning with user ID #0:
(or read card# 23456789)
NOTE:
The add user function code places you into this function programming mode. Press the add
user function code only before adding the first user. To continue to add other users in the same
session, do not repeat the add user function code .
