ENFORCER Outdoor Stand-Alone/Wiegand Keypad with Proximity Reader
SECO-LARM U.S.A., Inc.
5
Status
Sounds
LED
Power on in standby mode
--
Red steady
In base programming mode
1 Beep
Red flashing
In function programming mode
1 Beep
Orange steady
Exit programming mode
1 Beep
Red steady
Successful operation
1 Beep
Green flash once
Unsuccessful operation
3 Beeps
Built-in alarm
Rapid beeping*
Red flashing rapidly
LED Indicators and Device Sounds:
*De-activate the built-in alarm by entering a valid user code.
1.
Find a suitable location to mount the keypad. Install at a
height convenient to most users.
2.
Using the included security wrench, remove the security
screw located on the bottom of the keypad (Fig. 1).
3.
Carefully remove the keypad from the housing base,
sliding the keypad slightly upwards.
4.
Using the housing base as a template, mark the holes
needed for the wiring and mounting screws and drill
needed holes (choose either of the two pairs of mounting
holes). Ensure that the wiring hole is large enough to
allow the wiring to be pushed in without crimping.
5.
Run wiring through the wall to the wiring hole in the wall
6.
Thread the keypad wires through the center of the keypad
base and connect all according to "Wiring Chart" on pg. 6.
7.
Carefully push the wires through the hole in the wall.
8.
Install the base using the included mounting screws and mounting screw anchors (if necessary).
Ensure the correct orientation as shown in Fig. 1.
9.
Finish assembly by reattaching the keypad to the base and securing with the security screw.
Important Notes:
1.
Always disconnect power before servicing the keypad. Do not apply power until all connection wiring
is completed.
2.
The keypad must be properly grounded. Use a minimum 22AWG wire connected to the common
ground wire. Failure to do so may damage the unit.
3.
All wiring and programming should be done by a professional installer to reduce the risk of improper
installation.
4.
Be sure to store this manual in a safe place for future reference.
Installation:
Fig. 1
Drill 2 mounting
holes
Drill at least ø
3
/
8
"
(ø9mm) wiring hole
NOTE:
For weatherproof installation, add a
bead of silicone sealant around the
base where it meets the wall.
Security
screw
IF USING THE KEYPAD WITH A MECHANICALLY OPERATED DOOR OR
GATE, MOUNT THE UNIT AT LEAST 15' (5m) FROM THE DOOR OR GATE
TO PREVENT USERS FROM BEING CRUSHED OR PINNED. FAILURE TO
DO SO MAY RESULT IN SERIOUS INJURY OR DEATH.
