ENFORCER Outdoor Stand-Alone/Wiegand Keypad with Proximity Reader
14
SECO-LARM U.S.A., Inc.
Programming the Output Mode and Time:
Examples:
1.
Delete User ID #501:
2.
Delete user code #6905:
3.
Delete a user card #56789012:
4.
Delete a user card by presenting the card:
Read Card
5.
Delete all users (if the master programming code is 631732):
The relay can be programmed to toggle the relay ON/OFF (toggle mode), or to trigger for a programmed
length of time up to 99 seconds before automatically turning OFF. The output can be used for locking or
unlocking a door or for a variety of functions that can be controlled with the keypad.
When programming the output mode and time, use the following general formula from within base
programming mode (see "Enter and Exit Base Programming Mode," pg. 7):
– Program Output Mode and Time function code (a short beep will sound and the LED will
change to steady orange)
– Output Mode and Output Time
Output Mode and Output Time:
– Start/stop (toggle) mode. In this case, the output starts when a user code is entered, and
stops when a user code is entered again.
to
– The output triggered by a user code lasts up to 99 seconds before automatically
turning off (1=500ms, default: 5 seconds).
NOTES:
For programming the output timing, 1=500ms. 2~99 represents full seconds.
The key returns you to base programming mode (the LED will flash red). Exit programming mode
by pressing the key (see "Enter and Exit Base Programming Mode," pg. 7).
Examples:
1.
Set the output to toggle mode:
2.
Set the output to 60 seconds:
Deleting Users (Continued):
