ENFORCER SECO-LARM SLI SK-2612-SPQ, Руководство пользователя

Страница: 15 / 20

ENFORCER Outdoor Stand-Alone/Wiegand Keypad with Proximity Reader
SECO-LARM U.S.A., Inc. 15
Programming Built-In Notification Sounds, LED, and Backlight:
Programming the External Alarm Output:
The keypad notification sounds, LED, and backlight may be disabled. Setting the keypad notification
sounds affects all sounds from the keypad, including keypad presses, successful card/code entry
notifications, duress alarm, and wrong-code alarm. When programming, use the following general
formula from within base programming mode (see "Enter and Exit Base Programming Mode," pg. 7):
– Program Notification Sounds/LED/Backlight function code (LED will change to steady orange)
– Enable/Disable Notification Sounds/LED/Backlight
Enable/Disable Notification Sounds/LED/Backlight:

– Disable notification sounds

– Enable notification sounds (default)

– Disable LED

– Enable LED (default)

– Disable keypad backlight

– Enable keypad backlight (default)
NOTES:

Disabling the notification sounds affects only the internal sounds and not the external alarm output.

The duress alarm and wrong-code alarm will trigger both the internal notification beep and the
external alarm, depending on their settings.

The key returns you to base programming mode (the LED will flash red). Exit programming mode
by pressing the key (see "Enter and Exit Base Programming Mode," pg. 7).
The external alarm sounds an external alarm when the tamper, duress, or wrong-code alarm (if
enabled, see "Programming the Wrong-Code Lockout/Alarm," pg. 16) is triggered. To program, use the
following formula in base programming mode (see "Enter and Exit Base Programming Mode," pg. 7):
– Program Alarm function code (LED will change to steady orange)
–
Alarm Disable/Enable and Alarm Time
Alarm Disable/Enable and Alarm Time:

– Disable alarm (factory default)

to – Enable and set the alarm time, 1~3 minutes (factory default, 1 minute)
NOTE: The key returns you to base programming mode (the LED will flash red). Exit programming
mode by pressing the key (see "Enter and Exit Base Programming Mode," pg. 7).
Examples:

Disable the external alarm:

Enable the external alarm and set it to 2 minutes: