ENFORCER Outdoor Stand-Alone/Wiegand Keypad with Proximity Reader
SECO-LARM U.S.A., Inc.
3
Quick Programming Guide:
Programming Tips:
Master programming code (6 digits) should be programmed before any other programming.
A steady red LED indicates that keypad is powered on and ready. The LED will change to orange
and a single beep will sound to indicate the device has entered programming mode.
Programming Instructions:
Follow the instructions below if the following covers your needs:
A new master programming code.
Setting one user code.
Setting one user card
A door-unlocked time of 4 seconds after the output is activated.
Access mode / security level set to "card or code" (default)
NOTE:
It's important to choose and fully understand the security level before adding users. For other
security levels besides the default, read their setup instructions carefully before proceeding.
1.
Enter base programming mode:
NOTE:
is the factory default master programming code. A new master
programming code (6 digits) should be set the first time you enter programming mode.
2.
Set the master programming code (6 digits):
NOTE:
is the new master programming code and must be entered twice.
3.
Set a user card to operate the output (unlock the door):
Read Card
NOTES:
chooses user ID #15 of 998 possible user IDs (0~997).
To add other users (card or code) do not repeat the initial function code .
4.
Set a user code to operate the output (unlock the door):
NOTES:
chooses user ID #10 of 998 possible user IDs (0~997).
is the new user code for user ID #10 (4~6 digits).
Do not assign the user code 8888 to any user ID.
To add other users (card or code) do not repeat the initial function code .
5.
Set the output time (skip this step if the default value of 5 seconds is acceptable):
NOTE:
sets the output delay time for 4 seconds.
6.
Exit programming mode:
One short beep will sound to indicated that the keypad has exited programming mode.
