76
900-00277-01-001 Rev A ©2021 OutBack Power. All Rights Reserved.
Service
5. Carefully remove the control board, pulling toward the front of the inverter, as shown in Figure 38
.
Figure 38 Dismounting Control Board
6. Replace the control board. Perform all previous steps in reverse order.
Insert the control board.
Replace the screws
H
. Do not tighten.
Replace the connectors
G
and
F
. See Figure 37
if necessary.
Replace the ribbon cable
E
and the SMA cable
D
. See Figure 37
if necessary.
Replace the securing screw
C
. See Figure 36 if necessary.
Tighten all screws
H
.
Replace the
A
UX
terminal block
A
. See Figure 36 if necessary.
Replacement is complete.
H
H
H
H
