58
900-00277-01-001 Rev A ©2021 OutBack Power. All Rights Reserved.
Operation
2. Place the battery on a level section of floor against the wall. The rubber bumpers will offset the battery
from the wall surface by
⅜
” (9.5 mm).
NOTE
: If the wall structure does not have studs with 16” spacing, the mounting surface should be
reinforced with attached plywood or similar material as shown in Figure 30.
3. Insert the brackets
E
into the top slots on the battery as shown in the Figure 30
inset. These brackets will
sit loosely until secured in the next step.
4. Two lag screws of
1
/
4
" thickness (
F
) are provided in the hardware kit. Using a
7
/
16
" socket, install the
brackets in place on the wall. Mount the brackets into 16” wall studs if available; otherwise, seat them in
the plywood. Once tightened, the brackets will hold the battery securely against the mounting surface.
Figure 30 Battery Mounting
Mounting is complete.
See the
Mojave ESS Planning Guide
for information on mounting the battery with the inverter.
10
16"
F
F
E
E
10
