Endress+Hauser Fieldgate FXA320, Руководство по эксплуатации

Страница: 53 / 106

5 Commissioning Fieldgate FXA320
51 Hauser
5.6.3 Field Information Server (FIS) Setup
Use the Field Information Server (FIS) to send messages via hypertext transfer protocol secure
(https).
The following information can be exchanged between the FIS and Fieldgate:
• Periodic Measured Value Transmission
at the transmission intervals set in Periodic Measurement Messages, see chap. 5.6.1.
• Device Configuration
Fieldgate sends its configuration to the FIS. If required, FIS can send back a new configuration.
• Time of Day
is synchronized every time Fieldgate establishes contact with the FIS. The time zone can be set
in Time Server Setup, see chap. 5.5.1.
• Firmware Update
If required, the FIS can start a Fieldgate firmware update.
Procedure 1 If not already active, press Switch to Administrator Mode => Settings => Message
– Scroll down to reveal the Mail Setup page.
– Enter your settings and confirm with Send.
Field Information Server
(FIS) Setup Parameter Description
Enable FIS Check this box to activate the FIS functionality of the Fieldgate.
FIS URL Enter the IP address or the URL of the FIS.
FIS Phonenumber The field appears only for the GSM version of the Fieldgate:
– Enter the telephone number of the FIS.
– If the Fieldgate is contacted via this number, it immediately generates a measured
value message for the FIS. The call is not answered.
Send Alarm Messages to FIS Check this box to send alarm messages to the FIS:
– Note: the FIS can forward alarm messages to other groups of receivers. Contact your
FIS administrator to set them up.
Send Limit Messages to FIS Check this box to send limit messages to the FIS:
– Note: the FIS can forward alarm messages to other groups of receivers. Contact your
FIS administrator to set them up.