41978-2-0321
Page 9
BEFORE YOU START
SAMPLE WARNINGS AND DEFINITIONS:
DANGER
Indicates a hazardous situation which, if not avoided, will
result in death or serious injury.
WARNING
Indicates a hazardous situation which, if not avoided, could
result in death or serious injury.
CAUTION
Indicates a hazardous situation which, if not avoided, could
result in minor or moderate injury.
NOTICE:
Addresses practices not related to personal injury.
____________________________________________________
1. Read the safety information on pages 3 - 5.
2. If located in the Commonwealth of Massachusetts,
please note the special requirements on page 6.
3. Where are you going to install the fireplace? See page 18.
4. Frame the opening. See pages 19, 27 and 28.
5. Install the gas lines. See pages 23 and 24.
6. Install the wiring. See pages 25, 26, 60 and 61.
7. Install the venting. See pages 32 - 47.
8. Install the fireplace. See pages 18, and 27 - 31.
9. Light the fireplace and troubleshoot. See pages 50 - 52,
and 54 - 56.
10. Show the homeowner how to opera
te the fireplace.
11. Show the homeowner how to do the basic maintenance.
UNPACKING THE FIREPLACE
1. Cut binding straps and shrink wrap.
2. Lift fireplace off of the pallet.
3. Remove cartoning material.
4. Verify that the fireplace and components have not been
damaged during shipping.
5. Set fireplace in a location near to its final installation location.
INSTALLATION CONSIDERATIONS - FIREPLACE
INSTALLATION GUIDELINES
When planning a fireplace installation, it’s necessary to
determine:
•
Gas supply piping (right side entrance).
•
Electrical supply requirements
(120V, 60Hz, 1 Amp) (right side entrance)
•
These models do not include the Accent Light assembly.
However, the Accent Light Kit may be purchased and
installed prior to fireplace installation. Instructions are
supplied with the Accent Light Kit and in this manual.
•
Proper opening size of framing required for installation of
the fireplace. Refer to the framing information on pages 19,
27 and 28.
In planning the installation for the fireplace, determine where the
fireplace is to be installed and whether optional accessories are
desired. Gas supply piping should also be planned at this time.
THE FIREPLACE CAN BE MOUNTED ON ANY OF THESE
SURFACES:
1. A flat hard combustible or non-combustible surface.
2. A raised platform of combustible or non-combustible material.
This fireplace must be supported by a rectangular frame of metal
or wood 2 x 4's. This frame should be attached to a metal or
wood panel extending the full width and depth of the fireplace.
See page 27.
The fireplace is designed to be installed in a zero-clearance
enclosure. This means that combustible materials must be
located at clearances specified or provided by standoffs or
spacers attached to the fireplace.
Combustible materials can come in contact with the nailing
flanges provided.
HOMEOWNER REFERENCE INFORMATION
Record the following information about your fireplace.
Model:
________________________________________
Date Purchased/Installed:
________________________
Serial Number:
_________________________________
Location On Fireplace:
___________________________
Dealership:
____________________________________
Dealer Phone:
_________________________________
Notes:
________________________________________________________________________________________
______________________________________________________________________________________________
