24032-2-1008
Page 36
CAUTION:
Label all wires prior to disconnection when servicing
controls. Wiring errors can cause improper and dangerous
operation. Verify proper operation after servicing.
Cleaning
The blower wheel will collect lint and could require cleaning once
a year. If the air output decreases or the noise level increases, it
indicates a dirty wheel.
Blower Motor
The blower motor does not have oiling holes. Do not attempt to
oil blower motor.
Wiring
The appliance, when installed, must be electrically grounded in
accordance with local codes or, in the absence of local codes, with
the
National Electrical Code, ANSI/NFPA 70 or Canadian Electrical
Code, CSA C22.1
, if an external electrical source is utilized.
This
appliance is equipped with a three-prong [grounding] plug for
your protection against shock hazard and should be plugged
directly into a properly grounded three-prong receptacle. Do
not cut or remove the grounding prong from this plug.
For an
ungrounded receptacle, an adapter, which has two prongs and a
wire for grounding, can be purchased, plugged into the ungrounded
receptacle and its wire connected to the receptacle mounting screws.
With this wire completing the ground, the appliance cord plug can
be plugged into the adapter and be electrically grounded.
WARNING:
Unplugging of blower accessory will not stop the heater
from cycling. To shut heater off: Turn temperature dial or
thermostat to lowest setting. Turn knob on gas control to
"OFF," depressing slightly. Do not force.
OPTIONAL BLOWER INSTALLATION INSTRUCTIONS
Figure 41
1
2
3
5
6
7
8
9
10
11
4
PARTS LIST
INDEX
NUMBER
PART
NUMBER
DESCRIPTION
1
R-1454
BRASS BUSHING
2
R-1499
RUBBER GROMMET
3
24231
BLOWER HOUSING
4
R-1410
STRAIN RELIEF BUSHING
5
R-9927
BLOWER ASSEMBLY
6
24225
BLOWER COVER
7
R-6159
CORD SET
8
R-9699
WIRE HARNESS
9
R-2503
FAN CONTROL
10
24222
FAN CONTROL BRACKET
11
R-2805
AUTO OFF/ON SWITCH
