Emerson Rosemount 2240S, Справочное руководство, Страница: 137 / 194

127
Reference Manual
00809-0100-2240, Rev DA
Service and Troubleshooting
October 2017
Service and Troubleshooting
6.4 Resource block error and status messages
Table 6-9. Resource Block BLOCK_ERR messages
6.5 Transducer block error messages
Error conditions that may appear in the Transducer block.
Table 6-10. Transducer Block BLOCK_ERR messages
Condition Name Description
Block configuration error
Configuration Error is used to indicate that you have selected an item in
FEATURES_SEL or CYCLE_SEL that was not set in FEATURES or CYCLE_TYPE,
respectively.
Simulate active
This indicates that the simulation switch is in place. This is not an indication that
the I/O blocks are using simulated data.
Device Fault State Set This bit is set when FAULT_STATE is active in device
Memory Failure This bit is set when FD Electronics Failure condition is generated
Lost Static Data This bit is set when NV checksum fails or NV is not initialized for static parameter
Lost NV Data
This bit is set when NV checksum fails or NV is not initialized for Non-Volatile
parameter
Power up
This bit is set when resource block is in initialization state or at the time of device
power up.
Out of Service The actual mode is out of service.
Condition Name Description
Other error
Set whenever XD_ERROR is non-zero. See also “Service tools in AMS Device
Manager” on page 134 .
Out of Service The actual mode is out of service.