User Manual
Chapter 3
GFK-2847Y
Aug 2020
Software
38
3.14.1
Configure Trap Destinations
TRAP Destinations are configured through the QuickPanel
+
Setup Tool by providing the IP
Address of the SNMP Manager to which Traps should be sent. The user can configure two
different Trap Destinations (IP Addresses).
Note:
If you do not want to be notified of Traps, you do not need to configure Trap Destinations.
To configure Trap Destinations
•
If Trap Destination(s) is/are configured after enabling the SNMP Agent on the device, it
is highly recommended that you subsequently disable and then re-enable the SNMP
Agent service on the device.
1.
From the Start menu, select System, open the QuickPanel
+
Setup Tool, and select
the SNMP Agent tab.
2.
Configure the Trap destination(s) of the SNMP Manager.
Figure 40: Specify IP Address(es) as Trap Destination(s)
3.
Click OK to save the changes.
Close the QuickPanel
+
Setup Tool, then re-open the tool to view the configured Trap
Destination details from the SNMP Agent tab.
3.14.2
Enable or Disable SNMP Agent
SNMP communication disabled by default on the QuickPanel
+
device for security purposes.
To enable or disable SNMP communication using the QuickPanel
+
OS Utilities Settings tool
refer to the procedure in Section 3.9.4, Enable or Disable SNMP Agent.
Note:
Enabling or disabling SNMP communication is a one-time user configuration.
NOTICE
