User Manual
Chapter 5
GFK-2847Y
Aug 2020
Mounting and Installation
52
Figure 53: Mounting Holes (all four edges) IC755CxS12CDx
Figure 54: Mounting Holes (all four edges) IC755CxS15CDx
5.4
Mounting and Installation Procedure
Observe the following guidelines to properly mount and install the QuickPanel
+
Operator
Interface:
Note:
To order replacement gaskets, refer to the part number listed in Appendix B:.
•
The enclosure should be of metal material.
•
The metal enclosure panel should ensure proper thickness and rigidity suitable to
minimize impact to the QuickPanel
+
unit.
•
The recommended torque for the plastic back cover and interior metal cover for the
10, 12, and 15” QuickPanel
+
display units that is accessed for panel updates and serial
port DIP Switches is 0.5 Nm (4.4 in-lb).
•
To avoid gasket degradation, limit repeated insertions or removals of the unit and
retightening of the mounting clips. For full protection, always use a fresh gasket.
