User Manual
Chapter 5
GFK-2847Y
Aug 2020
Mounting and Installation
63
IP Address Setting
The QuickPanel
+
Operator Interface provides two methods to set an IP address:
•
DHCP (Dynamic Host Configuration Protocol)
•
The network server assigns an IP address during QuickPanel
+
initialization. There must
be a DHCP server on the connected network for a valid IP address to be assigned.
Contact your network administrator to ensure correct DHCP server configuration.
•
Manual Method
•
Specify the numeric addresses obtained from your network administrator for the
QuickPanel
+
IP Address, Subnet Mask and Default Gateway (if applicable).
Note:
Run the
to save the settings.
5.7.3
Serial Port Details
IC755CxS06RDx
Adhere to the following guidelines:
•
A terminal block is supplied with the unit.
•
The mating terminal block supports stranded 30 to 14 AWG (0.05 to 2.00 mm2) wires.
•
At a minimum, the cable must be rated for 75°C (167°F), or more.
•
Secure the serial cable to the mating connector while noting signal orientation and
tighten the screw clamps.
•
The torque for the attaching screws is 0.3 Nm (2.66 in-lb).
Serial Port COM1 Details
Interface: x1 RS-232
Connector: Euro Terminal (Tyco Electronics 284539-5)
Mating Connector: Tyco Electronics 284510-5
