Emerson FloBoss 107, Инструкция по эксплуатации, Страница: 42 / 152

FloBoss 107 Instruction Manual
2-10 Installation and Use Revised June-2017
2. Slide the base unit to the right.
Note: You should feel the retaining clips attach to the back of the
base unit and the attachment posts should appear in the right-
most holes on the base unit’s plastic housing.
3. Secure the base unit to the adapter plate by placing two #8 mounting
screws in the upper and lower right-most holes in the base unit.
Torque screws to 10-12 in-lbs.
4. Place the expansion rack on the right side of the adapter plate so that
the attachment posts touch the left-most inside of the plastic housing.
The connector on the expansion rack should be adjacent to, but not
touching, the connector on the base unit.
5. Slide the expansion rack to the left until the connectors seat firmly
together.
Note
:
You should feel the retaining clips attach to the back of the
expansion rack and the attachment posts should appear in the
left-most holes on the expansion rack’s plastic housing.
6.
Secure the expansion rack to the adapter plate by attaching two #8
mounting screws in the upper and lower left-most holes in the
expansion rack. Torque screws to 10-12 in-lbs.
Note
:
Adding an expansion rack and the modules may require you to
adjust your FB107 power consumption requirements. Refer to
Chapter 3, Power Connections.
2.2.4 Removing an Expansion Rack
Note
:
Before you remove an expansion rack, you must power down the
FB107 and disconnect all wiring from all modules.
To remove an expansion rack from an existing FB107 base unit:
1. Remove power from the FB107.
2.
Disconnect all wiring from all modules
3.
Unscrew the four screws that secure the expansion rack to the wall.
Note
:
If you are using an optional adapter plate, remove the four
retaining plate screws.
4.
Gently slide the expansion rack to the right away from the FB107
base unit.
Note
:
The expansion rack detaches quickly. Hold it securely to
prevent it from falling.
5.
Restore power to the FB107.