Emerson FloBoss 107, Инструкция по эксплуатации

Страница: 125 / 152

FloBoss 107 Instruction Manual
Revised June-2017 Troubleshooting 7-7

Use a cold start to restart without a portion of the configuration, log
data, or programming that may be the trouble. To perform a cold start,
open ROCLINK 800 software, connect to the FB107 and select
ROC
> Flags . Click Cold Start on the Flags screen.

Following a warm start and a cold start, if you still cannot connect
and you cannot connect to the FB107 using the LOI port, use the
reset switch on the FB107’s CPU module and cycle power to restore
the LOI communications parameters to factory defaults. Refer to
Section 7.4.1, Resetting the FB107 .
Note: If these methods do not solve the problem, contact your local sales
representative.
7.3.6 Powering Up
If you are experiencing trouble with powering up the FB107:

Ensure that power is applied to the FB107.

Verify the wiring connections at PWR+ and PWR

.

Verify the wiring connections at the power source.

Verify the input voltage, which should be a minimum of 8 volts dc
(refer to
Chapter 3, Power Connections ).
Note
:
If these methods do not solve the problem, contact your local sales
representative.
7.3.7 Multi-Variable Sensor (MVS)
If you are experiencing trouble with a MVS point:

Review Section 6.1, Multi-Variable Sensor (MVS) Module Overview
in Chapter 6, Sensors and Transducers .

Use ROCLINK 800 to see how the channel is configured.

If more than one MVS is connected to the FB107, use the Multi-
Variable Sensor screen (
Configure > I/O > MVS Sensor ) to ensure
that each MVS has a unique address.
7.3.8 Resistance Temperature Detector (RTD)
If you are experiencing troubles with the RTD:

Use ROCLINK 800 to verify that the on-board RTD point is
configured as point number AI3 (RTD=AI3).

If the configuration looks correct, then use ROCLINK 800 to produce
a simulated input (within the range of the input) according to the
following values: