ELNA eXtend 864air, Руководство пользователя

Страница: 54 / 64

52
q
w
z
x c v
b
n m ,
q
e
r
t
y
u
i
o
!0
t
!1
r
e
Open the looper cover.
With a forward brushing movement, use the lint brush to
remove any lint.
q
Lint brush
* You may use a vacuum cleaner to clean the upper
knife area or feed dog.
CARE OF YOUR MACHINE
Cleaning the Upper Knife Area
CAUTION
Make sure to turn the power switch off before cleaning
the machine.
CAUTION
Make sure to turn the power switch off before cleaning
the machine.
Cleaning the Feed Dog
z
Position the chaining finger lower than the surface of
the needle plate by pulling the chaning finger switch
knob toward you to “R” (refer to page 13).
q
Chaining finger
w
Chaining finger switch knob
x
Open the looper cover and the side cover.
c
Remove the needle and the presser foot (refer to
pages 9 and 10).
v
Remove the setscrew with the large screw driver and
remove the needle plate.
e
Setscrew
r
Needle plate
t
Large screwdriver
b
Use the lint brush to remove any lint from around the
feed dog.
y
Feed dog
u
Lint brush
n
Attach the needle plate by inserting the rib under the
edge of the rear cover and aligning the hole in the
needle plate with the pin.
Tighten the setscrew with the screwdriver.
e
Setscrew
r
Needle plate
t
Large screwdriver
i
Needle plate hole
o
Rib
!0
Pin
!1
Edge of rear cover
m
Attach the needle and the presser foot.
,
Close the side cover and the looper cover.
ODRŽAVANJE MAŠINE
Čišćenje područja gornjeg noža
PAŽNJA
Obavezno isključite glavni prekidač pre čišćenja
mašine.
Otvorite poklopac petljača.
Četkicom uklonite nakupljene ostatke konca i tkanine.
Četkica za čišćenje
Za čišćenje područja gornjeg noža i donjeg transportera
možete upotrebiti i usisivač.
PAŽNJA
Čišćenje donjeg transportera
Postavite lančani prst niže od površine ubodne
Obavezno isključite glavni prekidač pre čišćenja
mašine.
ploče, povlačeći taster lančanog prsta ka sebi
u položaj "R" ( detalje pogledajte na strani 13 ).
Lančani prst
Taster lančanog prsta
Ovorite bočni poklopac i poklopac petljača.
Uklonite igle i stopicu (detalje pogledajte na
stranama 9 i 10 ).
Uklonite šrafofe velikim šrafcigerom i uklonite
ubodnu ploču.
Šraf
Ubodna ploča
Veliki šrafciger
Četkicom uklonite nakupljene ostatke konca
i tkanine iz donjeg transportera.
Donji transporter
Četkica
Vratite ubodnu ploču, umetanjem zareza ispod
ivice zadnjeg poklopca poravnavajući otvor
na ubodnoj ploči sa izbočinom.
Zategnite šraf velikim šrafcigerom.
Šraf
Ubodna ploča
Veliki šrafciger
Otvor na ubodnoj ploči
Zarez
Izbočina
Ivica zadnjeg poklopca
Vratite igle i stopicu.
Zatvorite bočni poklopac i poklopac petljača.