62
Cutting the Threads
After sewing is stopped, press the “Auto Thread
Cut” key
q
(LED signal turns on). (Needle should
be in down position before using auto thread cutting
mechanism to avoid extra needle penetrations.)
Raise the presser foot and remove the fabric.
Pull both threads to the back under the presser foot
so they are ready for sewing again.
OR
Specialty or heavy decorative threads: Press the
“Up/Down Needle” key to raise the needle. Raise
the presser foot. Remove the fabric; pull the threads
to the back and cut threads using the thread cutter
w
. (The threads are cut the proper length to start
the next seam.)
q
w
q
Changing Sewing Direction
Stop the machine and press the “Up/Down Needle”
key
q
to bring the needle down into the fabric.
Raise the presser foot using either the presser foot
lever or knee lifter.
Pivot the fabric around the needle to change sewing
direction. Lower the presser foot. Sew in new
direction.
Adjusting Needle Position
When you press the “Stitch Width/Needle Position”
key, the needle position can be set between 0.0
and 7.0.
Press the top/left “–” side of the key to move needle
left.
Press the bottom/right “+” side of the key to move
needle right.
q
Left position
w
Center position
e
Right position
The following stitches also have variable needle
position: 6, 011, 012, 061, 062 and 063.
q
w
e
