Elliott Digger Derrick, Руководство по эксплуатации и техническому обслуживанию, Страница: 329 / 376

12
DM-R2170-0002A
www.omnexcontrols.com call toll free: 1-800-663-8806
Light Legend
Solid
Slow
Flash Fast
Flash Red
Light Green
Light Alternating Red
& Green Light Yellow
Light
The R2170 requires a transmitter ID from an OMNEX wireless transmitter before it can be operated. The R2170 can
only hold a single transmitter ID; if another ID is downloaded then the new ID will overwrite the previous ID. OMNEX
transmitter IDs are unique, ensuring that the R2170 will only respond to the correct transmitter.
A
B
SW 1
Button
CAN 2
CAN 1
ESTOP
LINK
STATUS
C
SW 1
Button
STATUS
LINK
ESTOP
CAN 1
CAN 2
Downloading the Transmitter ID
A. Press and hold [SW 1] on the front of the
R2170
B. Hold [SW 1] until the (Status) light begins
to flash GREEN quickly
C. When this occurs, release the button to
enter Setup mode.
D. If the [SW1] button is held for more than
10 seconds, the (Status) and (Link) LEDs
will rapidly flash RED showing the “stuck
switch” indicator.
CAN 2
CAN 1
ESTOP
LINK
STATUS
CAN 2
CAN 1
ESTOP
LINK
STATUS
D
1. Setting R2170 into Configuration Mode
NOTE: For this document, orientation
of the paddle and switch operation will
be defined as follows:
Paddle UP—is towards the switches
Paddle DOWN—is away from switches
Switch UP—is away from paddles
Switch DOWN—is towards the paddles.
UP DOWN
NOTE: The R2170 will only remain in Setup Mode for 30 seconds. If a transmitter ID is not successfully
received during this time, the R2170 will exit Setup Mode. The (Status) and (Link) lights will also flash RED
to indicate that there was an error downloading the transmitter ID. If this happens try downloading the
transmitter ID again as described above. Pressing [SW 1] again will stop the (Status) and (Link) lights from
flashing RED.
CAN 2
CAN 1
ESTOP
LINK
STATUS
Unsuccessful ID
download