159
ON/OFF radio control of a MTR2000ER via an E4BPP channel
E4BPP wiring to the control panel with electrical output
SD542-9000
(*) WARNING: CONTROL PANEL HW CONFIGURATION
IMPORTANT
CONTROL PANEL SW CONFIGURATION
DIRECT CONNECTION
INSTANTANEOUS MODE CONFIGURATION (=ON/OFF)
E4BPP
U
X
Temporary pushbutto
n
Co
nt
ro
l p
an
el
OUTPUT N.L.
O. COMMANDABLE
B
V
E
/ M
/ V
/ G
V
E
= green wire
M
= brown wire
V
= purple wire
G = grey wire
B = white wire
-V
1
Jumper position
-
+
{
(*)
If
a
Control
panel
electrical
output
is
used,
the
corresponding
jumper
must
be
moved
to
the
position
"
-
"
before
connecting
the
transmitter.
Otherwise,
the
transmitter
will
be irreparably damaged.
By
using
the
keypad
or
the
Hi-Connect
programming
software,
configure
the
output
as
follows
:
- OUTPUT TYPE = OUTPUT N.L.
- CUSTOMIZE = O. COMMANDABL
E
Briefly press 5 times the temporary pushbutton connected to the transmitter. The transmitter
LED will start flashing for 30 seconds to indicate that it is waiting for connection.
While
the
transmitter
LED
is
flashing,
shortly
press
the
MTR2000ER
"connect"
hole
located
in the rear part with the tip of a pencil.
The transmitter LED will stop flashing.
Warning!
The receiver must be powered on.
Briefly
press
10
times
the
temporary
pushbutton
connected
to
the
transmitter
to
enter
the
Configuration Menu: the transmitter LED will start flashing rapidly
.
While
the
LED
is
flashing,
briefly
press
the
pushbutton
17
times:
the
transmitter
LED
will
respond by flashing 7 times.
From
now
on,
the
light
connected
to
MTR2000ER
will
be
correctly
piloted
by
the
control
panel
or the expansion in the ON/OFF mode.
