18
Installation/Configuration ER600
6.4
IDENTIFYING A BUS DEVICE
6.4.1
Interrogating a bus device
In order to find the address of a device already acquired on the bus, following the instructions below:
1. Activate the maintenance mode to avoid generating tamper events.
2. Press and release the programming button of the device whose address you want to know.
3. The yellow LED of the device will emit a series of flashes equal to the number of its address.
6.4.2
Searching for a device
To identify a specific device on the bus, follow the instructions below:
1. Activate the maintenance mode to avoid generating tamper events.
2. Select «MAINTENANCE» / «SHOW ADDRESSES» from the Installer menu.
3. Then select the type of device to be identified in the submenu and select its address from inside the list it proposes; confirm by pressing
OK
. The message “IN PROGRESS…” appears.
4. Then look at all the devices installed: the one with the address requested will have the yellow acquisition LED flashing quickly and
is valid for radio expansions.
5. Press
ESC
to conclude the search.
IMPORTANT!
It is possible to interrogate and/or search exclusively devices connected to the data Bus.
6.5
DELETING A BUS DEVICE
To remove an existing device from the bus, simply delete its address by following the instructions below:
1. Activate the Maintenance mode.
2. Select «MAINTENANCE» / «DELETE» from the Installer menu.
3. Select the type of device to be deleted and select its number from within the list proposed. The device is no longer considered connected to
the control panel and its memory will be restored to default values
4. Turn off the entire system.
5. Physically disconnect the device from the bus.
6. Then power up the system again.
To restore the device removed to default parameters in order to reacquire it again, it is necessary to reset it.
IMPORTANT!
The control panel automatically saves at least one keypad.
If a device must be replaced, use a keypad to delete the device, proceed with the removal and the connection of the new device, and
finally proceed with the acquisition procedure.
Otherwise, the new device can be pre-acquired with the same address as the one to be replaced by using another control panel and
positioning it directly in the system.
6.5.1
Deleting an ER600 radio expansion
The procedure to delete a radio expansion is the same as the one to remove any bus device, as described in the previous parag raph.
However, as it takes a longer time, it is useful to highlight some differences:
1. Select «MAINTENANCE» / «DELETE» from the Installer menu.
2. Select
the
«RADIO
EXP.»
submenu
and
select
the
radio
expansion
from
among
those
available.
The yellow LED “
B
” (see
Figure 3 - ER600 radio expansion
) of the device flashes quickly for 40 seconds; the delete operation is
concluded only when the LED stops flashing and remains on steadily.
3. Turn the system off.
4. Physically disconnect the device from the Bus.
5. Then power up the system again
.
IMPORTANT!
When deleting a radio expansion, all the radio devices associated with it are automatically deleted. At the same
time, the “Radio Devices” menu will no longer be displayed on the system keypads.
