Installation/Configuration ER600
31
17) Press
. Press
and
to assign the input to the SYSTEM (all partitions) or only to some
PARTITIONS. Press
to confirm.
18) If SYSTEM is selected, press
ad
to select SYSTEM ASSIGN or SYSTEM DO NOT
ASSIGN and press
to confirm. Then
.
19) The screen page shown here by the side will appear if PARTITIONS is selected. The empty boxes
represent partitions which are not assigned to the input and the black boxes the partitions which
have already been assigned. Press
and
to select the partition to be associated. Press
and
to assign the partition (the square will turn black) or to disassociate it (the square will
appear empty). Repeat the procedure for all partitions to be associated to the input. Press
at
the end.
20) Press
and then
.
21) Press
. Press
and
to customise the output customisation. Press
to confirm.
22) Press
and then
. Press
and
to enable and select how to report status. Press
to
confirm.
23) Repeat the procedure from step 6 to program another radio expansion module siren. Press
again to program the other radio expansion module repeating the procedure from step 3.
24) Press
repeatedly to exit from the menu
9.3
RC600 REMOTE CONTROL PROGRAMMING
The flow chart shown below illustrates the remote control programming procedure after it has been acquired by the MP500/4N,
MP500/8 or MP500/16 - ER500 control panel.
The menu is shown as it actually appears on the keypad display for the sake of simplicity. The navigation and confirmation keys are
also shown to provide step-by-step help to the installer during the programming procedure.
IMPORTANT!
Only one ER600 module can be acquired by the MP500/4N control panel.
ASSIGN
SYSTEM
SE##:
□□□□□■□
DC01.In1: InNNN
CUSTOMIZE
CUSTOMIZE
O BURGLAR ALARM
SIRENS
STATUS REPORT
