29
Handheld & Panel Mount - Remove the top cover on
the controller with a phillips screwdriver.
OEM Interface Module - Remove the cover with
a phillips screwdriver to locate the USB port.
OPEN – opens the valve. If the button is released, the valve will remain in the current
position until another valve operation is performed.
o
In order to initiate auto-travel open, press and hold the OPEN button, then press
and release the CLOSE button, then release the OPEN button. The valve will then
auto-travel to fully open.
CLOSE – closes the valve. If the button is released, the valve will remain in the current
position until another valve operation is performed.
o
In order to initiate auto-travel close, press and hold the CLOSE button, then press
and release the OPEN button, then release the CLOSE button. The valve will then
auto-travel to fully closed.
PRESET – Opens or closes the valve to a preset position
o
To Change Valve Preset, move the valve to the desired position.
o
Press and hold the PRESET button for 10 seconds
o
The PRESET button will now bring the valve into this position when pressed outside of
Setup Mode
TRIGGER (Joystick Only) – When the Joystick TRIGGER is pulled, the valve will begin
opening and stay open as long as the TRIGGER remains pulled. When the TRIGGER is
released, the valve will close.
M. Auxiliary
Turn on/off optional light 1 – Hold AUX and press FOG
Turn on/off optional light 2 – Hold AUX and press STREAM
N. Write Diagnostic File
Power up all EXM system components.
Remove the USB cover from any input controller. (If the system has more than one
controller select the one with the easiest access. See illustration below for locations of
the USB connection)
Install a blank USB flash drive into the USB port of the desired input controller, and the
controller will automatically enter USB Mode (The following LED routines should occur to
indicate USB mode has been initiated. If USB Mode does not initiate, hold AUX and OSC
for 2 seconds and watch for the LED indicators)
