15
1
1
2
RF Transceiver in OEM Module
If the 7070 OEM Interface Module will use RF communication, install the RF Transceiver
Module as described in the following steps.
o
Remove the cover from the OEM Interface
Module using a Phillips screwdriver.
o
Connect the RF Transceiver with the wires
running the length of the board as shown
here.
o
Remove and use the three screws on the
gray plate inside the OEM Interface Module
to hold the RF Transceiver in place within the
OEM enclosure.
o
If external RF antenna module 7062 is required, refer to the External RF Antenna
Module section on the following page.
o
Reattach the cover to the OEM Interface Module.
Supply power to the OEM Interface Module and Joystick by connecting the red and
black leads coming from plug 1 to an appropriate power source.
Install a 1 Amp fuse into the positive power lead of the OEM Interface Module for a
12V system (1/2 Amp for 24V system).
Refer to the respective plug figures for information on the plugs’ pins.
For information regarding external switches and customer supplied joysticks, refer to
the pin information found on the OEM Interface Module cover and the OEM Interface
Module Wiring Supplement manual (P/N 98535000).
o
If using a customer-supplied joystick or switches, all controls being used with the
OEM Interface Module must be customer-supplied.
o
Customer-supplied controls/switches and the Elkhart Brass Joystick may not be
used simultaneously.
If there are any unused OEM Interface Module connections plug the connections with
appropriate Deustch connectors and plugs.
Position Feedback Display –
Using the Position Display template shown in
the Component Mounting Templates
section, drill the two 11/64” holes shown
through the panel intended for mounting
the display.
Mount the Position Feedback Display using
two (2) 6-32 x ½” fasteners secured with blue
Loctite 242 or equivalent.
Connect plug 2 leads to the appropriate
CAN line.
