12
1
2
1
2
RF Transceiver in Panel Mount
1
2
Connecting an OEM supplied proximity sensor to the wire from position 3 will provide
conditional extended travel functionality via a ground or open circuit (see Operating
Instructions). Connecting the proximity sensor wire from position 3 to a ground will provide an
always enabled extended travel.
Panel Mount Controller -
Using the Panel Mount Controller template in the
Component Mounting Templates section, drill any
4 of the 7/32” holes shown through the panel
intended to hold the Panel Mount.
Mount the controller with four (4) 10-24 x ½” screws
using blue Loctite 242 or equivalent. Screw length
should provide 0.187”-0.25” thread engagement
into panel mount. Torque screws to 50-60 in-lbs.
If the Panel Mount will use the CAN line to
communicate with the other EXM components,
connect plug 1 leads to the appropriate CAN line.
If the Panel Mount will use RF communication,
install the RF Transceiver Module into the controller.
o
Remove the back cover from the Panel Mount
Controller using a flathead screwdriver.
o
Connect the RF Transceiver with the wires running
the length of the board as shown in the picture to
the right.
o
Reattach the back cover of the Panel Mount.
Ensure no wires are pinched.
o
If the CAN leads will not be used, replace wires
with appropriate plugs.
Supply power to the controller by connecting plug 2 leads to an appropriate power
source.
Install a 1 Amp fuse into the positive power lead for a 12V system (1/2 Amp for 24V
system).
Refer to the respective plug figures for information on the plugs’ pins.
