Elka P 2500, Инструкция по установке и эксплуатации

Страница: 7 / 58

P 2500 - P 5000
6
2.4 Intended use – Vehicle traffic
The operational safety can only be ensured when the barrier is used as
intended.
After installation, the barriers of series P 2500-5000 serve as passage control
of vehicle paths exclusively of usage class Vehicular III and IV.
CAUTION!
Danger of impact and crushing!
With inadequate safety measures the movement of the
barrier boom can result in impact or crushing points
between the boom and solid objects within the movement
area.

In order to reduce the risk potential by a moving barrier
arm, additional safety devices of type B1 or B2
according to UL 325 (see table 31.1 of UL 325) should
be installed. The internal entrapment protection system
of the barrier P 2500-5000 corresponds to type A.
 Two independent entrapment protections must be
installed before commissioning.
 For the reversal of the gate, P541 must be set to "1"
andP542 must be set to "0". See "Installation and
operation instructions Part 2" sec. 2.2.5.6 and 2.2.5.7.
 The gate operator must be equipped with an audio
alarm. See "Installation and operation instructions Part2"
sec. 2.2.5.11.
The controller is a product component and serves to control the barrier.
Any use above and beyond the above mentioned use is prohibited and
constitutes improper use.
2.5 Danger, which could emanate from the site of operation
The barriers P 2500-5000 operate with moving parts.
WARNING!
Rotating and/or linear movable components can cause
serious injuries.
Do not reach into moving parts or handle any moving
components during operation.
 Turn the appliance off before any maintenance work,
repair work or other work and secure it against
unintentional restarting.
2.6 Non-factory technical alterations and extensions
Non-factory technical alterations and/or extensions may result in hazards as
well as interfere with the function of the barrier.