Ness
-M1XEP Installation Manual
Page 13
Connecting
Ness
RP to the Control over a Network
1. Start the
Ness
RP program and create or open an account.
2.
Look at the lower right side of the "Account Details" screen for the two data entry blocks labeled: "System URL/IP"
and "Port".
3. If
Ness
RP and the Control are both on the
same network
, the IP address and port should have been copied from the
M1XEP setup screen during the configuration and setup process. Verify that the values are correct.
4. If
Ness
RP will connect to the Control
through the Internet,
fill in the IP address and port manually.
a.
If the M1XEP is connected through a network router, you will need to enter the IP address or URL for the entire
local network. The router must be programmed to allow outside traffic through a specific port. For information
on setting up your router, please refer to section 6 on page 12 and your router documentation or contact the
manufacturer of the router.
b.
If the M1XEP is not connected through a network router, enter the values found on the TCP/IP tab of the
M1XEP Setup screen.
5.
Make sure that the serial number is correct and the "RP Access Code" is set to the correct value programmed into
the control (default=246801). From the Connection menu choose the "Network" method.
6. If everything is setup properly
Ness
RP should now connect to the Control through the M1XEP.
