Elite Greenhouses 7'5" WIDE TITAN, Инструкции и иллюстрации

Страница: 14 / 32

DOOR END ASSEMBLY
Components required
Door end cill
2 Built in base cills
2 Long door end block glazing bars
2 Rectangular plates with 3 holes
2 Short horizontal braces
2 Roof corner bars (marked ‘R’)
2 Side corner bars (unmarked)
1 Main door track support
1 Top door track
2 Small door track support flat bar
2 Base legs/corner brackets (approx. 400mm long)
You will also require 2 eave plates and 1 ridge plate. These are packed with the casement stay and
are separate from the main bag of fittings.
From the main bag of fittings you need: nuts and bolts, glazing beading and gusset plates – 1 large
(ridge plate) 2 small (eave plates). Remember, these plates are
not in the pack of fittings but are
taped together with the casement stays elsewhere in the box!
PROCEDURE: The format for the door end is identical to the rear end assembly up to and includ-
ing step 10 so please refer to those items in the previous pages.
1. Now attach the small built in base section to the corner bars, leaving a space for the doors in
between.
2. Now engage the door end cill with the 2 built in base cills by pushing the angle of the cill un-
der the locator as shown in the diagram. At this stage the cill will move freely left and right
but will remain located to the built in base cill. (See diagram below). The bottom cill is not as
wide as the greenhouse, it is approx. 300mm shorter, i.e. 150 mm at each side.
3.
The long block glazing bars have 2 bolt channels on the inside face. When in position, slide 2
bolts into the bottom of the channel closest to the corner bar, and 1 bolt into the channel clos-
est to the door opening. Slide 3 bolts (only 1 if greenhouse to be sited on soft ground) into the
free end of each built in base section. Attach the bottom bolt in the block glazing bar to the
holes in the door end cill, but do not put a nut on yet.
Remember, the door end block glaz-
ing bars are 95 mm longer than the rear end ones and do not sit on top of the base (as
the rear end block glazing bars do), they go down the side of the base and attach to the
bottom cill. (Key point)
4.
Attach the rectangular plate (with 3 slotted holes) to the 2 bolts inserted
in the block glazing bars and the last bolt inserted into the base ensur-
ing that the block glazing bar is tight down into the angle of the door
end cill. Attach the diagonal angle to the top bolt of the rectangular
plate, and then to the
bottom bolt of the
eaves gusset plate. The 2 unoccupied
bolts in the base sections will be used to
anchor the greenhouse to the floor.