Eliet GZC 1000, Руководство пользователя

Страница: 46 / 92

46
English
Failure to clean the machine can cause:
1. increased wear of the bearings
2. Increased wear of covers
3. Jamming of moving parts
4. Reduced cooling
5. Risk of fire
6. Inability to notice cracks or tears
7. Damage to the paint
8. Illegibility of stickers
• It is therefore recommended to clean the machine after each use. Cleaning the machine can
also be regarded as a visual check. It offers an opportunity to timely notice any breakage or
need for lubrication.
Tip : clean the machine immediately after working with the machine. Mud and soil then won’t
have a chance to dry up and stick to parts which makes cleaning and rinsing considerably easier.
Caution:
Wear suitable clothing for cleaning activities. Utility gloves are necessary.
The following points require special attention:
• Always remove the seed from the seed reservoir after working with the machine (use a
vacuum cleaner to remove the seed from the deeper lying areas).
• Also check that the seed funnels are completely free.
• The engine should be clear of dust and dirt. More in particular the cooling fins, the exhaust and
the area around the exhaust must be clear. The area around the fuel cap must be kept clean to
avoid dirt entering the fuel tank. Blow away any dirt that might block the throttle control.
• Check and clean the air filter on a regular basis.
• Check and lubricate the chain drives.
• The bushings must be cleaned from sand and dirt that sticks to the lubricating grease. After
cleaning, apply new lubricant (see § 11.2 Lubricants for a list of lubricants).
• Use a dry cloth or soft brush for cleaning, and penetrating oil with MoS2 to remove grease and
lubricants. The latter is a lubricant and rust solvent at the same time.
• The transmission parts and hinges located under the large cover must be kept dust free as
much as possible.
• Clean the vibrating harrows. Use a water sprayer to rinse off any persistent dirt.
• Check that the vibrating harrows are not damaged or bent.
• Clean the traction rollers so any dirt won’t cling. Also clean the scraper (if present) of the anti-
scalping roller.
• Use a dry cloth to remove dirt from the chassis and more specifically from the stickers with
safety instructions.