Electrolux 2.7 Cu. Ft. Tubs, Руководство по обслуживанию

Страница: 75 / 80

75
Removing the top half of the tub seal:
1. Disconnect the washer from electrical supply.
2. Remove the agitator, spin basket and trunnion.
3. Push down on the brass ring to release the rubber
seal and pull the seal and brass ring off the shaft.
Removing the bottom half of the tub seal:
1. Disconnect the washer from electrical supply.
2. Remove the agitator, spin basket, trunnion and top
half of the tub seal
3. Place your thumbs on the bottom seal towards you
and your fingers on the other side. Push down and
in with your thumbs and pull in and up with your
fingers to pop the seal out.
Removing the outer tub:
1. Disconnect the washer from electrical supply.
2. Remove the agitator, spin basket, trunnion and top
half of the tub seal.
3. Disconnect the drain hose, drive motor shield and
the pressure switch hose.
4. Using a 1/2” socket remove the three bolts holding
the tub to the leg and dome assembly, and lift the
tub over the transmission shaft.
Removing the tub bearing:
1. Disconnect the washer from electrical supply.
2. Remove the agitator, spin basket, trunnion, top half
of the tub seal and tub.
3. Turn the tub over and remove two screws holding
the bearing to the tub.