76
Removing the drive belt:
1. Disconnect the washer from electrical supply and
remove the front panel.
2. Check the setting of idler pulley spring.
3. Push in on the idler pulley and turn the belt off.
Removing the transmission pulley:
1. Disconnect the washer from electrical supply,
remove the front panel and the drive belt.
2. Using a 3/8 socket, loosen the locking screw of the
transmission pulley and drop the pulley off the
shaft.
Removing the transmission:
1. Disconnect the washer from electrical supply,
remove the front panel and the drive belt.
2. Remove the agitator, spin basket, trunnion, tub
and transmission pulley.
3. Using a 3/8 socket remove the two bolts holding the
transmission bearing block to the transmission
mounting plate and remove transmission.
Replacing the vertical springs:
1. Disconnect the washer from electrical supply and
remove the front panel.
2. The three vertical springs are not the same. The
springs are identified by two them being painted.
The spring without the paint goes in the left rear
across from the motor.
WITHOUT PAINT
Содержание 2.7 Cu. Ft. Tubs
Страница 10: ...10 Caution Disconnect Electrical Current Before Servicing ...
Страница 11: ...11 ...
Страница 35: ...35 ...
Страница 80: ...80 ...