Electrolux 2.7 Cu. Ft. Tubs, Руководство по обслуживанию

Страница: 37 / 80

37
Auto temp system
The auto temp system is made up of the auto temp
control, mounted to the left end cap of the console and
a positive thermal sensor connected in the water hose
between the water valve and the water inlet.
When the temperature selector switch is set to regulated
warm/warm, electrical power is supplied to the hot water
solenoid by contacts FF and H of the temperature
selector switch. The auto temperature control cycles
the cold water solenoid using the information received
from the sensor to control the wash water temperature
to 90 +/- 5 degrees F.
When the temperature selector switch is set to regulated
warm/cold, electrical power is supplied to the hot water
solenoid by contacts F and H of the temperature
selector switch. The auto temperature control cycles
the cold water solenoid using the information received
from the sensor to control the wash water temperature
to 90 +/- 5 degrees F.
When the temp selector switch is set to regulated cold/
cold, electrical power is supplied to the cold water
solenoid by contacts FF and C of the temperature
selector switch. The auto temperature control cycles the
hot water solenoid using the information received from
the sensor to control the wash water temperature to 70
+/- 5 degrees F.
End of cycle signal switch
The end of cycle signal switch is located in the console.
The switch controls power to the end of cycle signal
which allows the user to turn end of cycle signal off or
on.
End of cycle signal
The end of cycle signal is mounted to the control
mounting panel in the console.
Auto temp board