ELBO CONTROLLI SETHY SIX, Инструкция по установке, эксплуатации и обслуживанию, Страница: 37 / 96

8 PRELIMINARY OPERATIONS ELBO CONTROLLI srl
SETHY SIX
Press “YES” to save, then press “ESC” to close the setup window.
8.2.3 Calibration of the 212V vision system
Follow this calibration procedure to define the pixel/micron ratio of the image sensor; this operation is
done during manufacturing, but you may need to repeat it when the sensor is substituted.
Vision system calibration procedure
•
Insert a tool in the spindle, focus the image and activate the spindle brake;
•
access the configuration page following para. 8.2.2
•
activate the calibration procedure pressing the “calibration” key;
•
autotargeting measurement will be automatically activated
•
on the screen the area of interest where you will have to indicate the shade of the cutting edge will
be highlighted
•
a message will ask you to touch the X axis in the left-hand area
•
move the X axis until the cutting edge shade is in the highlighted area and press the “OK” key to
confirm
•
the next messages will ask you to touch the X axis in the right-hand area , then the Y axis in the
upper area, finally the Z axis in the lower area
•
after every input, press the “OK” key to confirm in order to proceed further
•
when the four points have been scanned correctly, a message will be displayed indicating that the
procedure is completed.
The following pictures show the calibration procedure:
Page 37 of 96