ELBO CONTROLLI E236+, Инструкция по установке, эксплуатации и обслуживанию

Страница: 15 / 71

5. PREPARATION AND INSTALLATION ELBO CONTROLLI srl
Preset E236+
15
The s’Print-S label printer must be connected directly to the serial RS-232 communication port of the
presetter.
Insert the telephonic type RJ11into the socket on the underside of the printer.
To supply the printer, insert the pin of the feeder on the back of the connector D-Type 9 pole (see figure)
and insert the feeder into the plug for electric current.
Open the cover of the printer and insert the roll of labels, after having freed it of the closing sticker and
having thrown away the first label with its residue:
ý
Restoration procedures of the settings of the label printer S’PRINT-S
The printer comes supplied ready for use with the E236+ presetter: it isn’t necessary to modify the settings
for the correct functioning .
This procedure must be followed solely in case of malfunction, in fact if the configuration of the printer
has to be cancelled, for example, following an electrical phenomenon in the mains supply, the restoration
of the printer settings should be modified because they are not apt for use with the E236+ presetter.
To access the configuration, disconnect the feeder from the mains supply, wait a few seconds, then keep
pressing the push-button , re-insert the printer feeder; when the printer starts a settings report let go of
the push-button:
E236 porta RS-232