FUEL BED LAYOUT Eko 3031 MODELS
Coal Effect Option
1. Remove the combustion matrix from its pro-
tective packaging, and position onto the burn-
er tray as shown. The front edge of the matrix
should sit snugly behind the back edge of the
burner rails. Do not fit the matrix on top of the
burner rails.
2. Next, remove the front coal strip from its
protective packaging and position as shown.
The rear edge of the front coal strip should fit
in front of the burner rail. Again, do not to
place on top of the burner rails. When the front
coal is in position bend up the three metal tags
at the front of the tray to retain (inset).
3. Open the bag of 16
moulded coals. All of the coals are the same.
Take five coals and place them as shown. Care
should be taken to ensure that the coals bridge
the gap between the front coal and the four
coal supports at the front of the matrix. Care
should also be taken not to push the coals
right down between the coal supports, as this
can detract from the flame picture when the
appliance is running.
4. Take five more moulded coals and position
as shown to form the ‘second row’ of the fuel
effect. The coals may be rotated as desired to
fit into the gaps between the coal supports in
order to create a random, realistic effect.
Again, remember not to push the coals down
too far into the valleys between the coal sup-
ports as this can have a detrimental effect to
the flame picture.
14
9.1
©
2009 Focal Point Fires plc.
