GAS CONNECTION
Refit the burner tray into the firebox, fit the two screws through the locating holes in the tray legs,
and tighten.
Purge the gas supply thoroughly to remove air
and dirt/debris
BEFORE
connection. Now dis-
connect the inlet restrictor elbow from the inlet
pipe. Connect the previously installed gas sup-
ply to inlet restrictor elbow, and re-fit the
restrictor elbow to the inlet pipe of the appli-
ance.
If using an across hearth connection, ensure
the decorative fireframe and firefront will clear
the supply route.
If the data/control plate is not already fitted,
attach with two screws, ensuring the control knob is free to be depressed fully.
FUEL BED LAYOUT
Coal Effect Option
1. Remove the combustion matrix from its pro-
tective packaging, and position onto the burn-
er tray as shown. The front edge of the matrix
should sit snugly behind the back edge of the
burner rails. Do not fit the matrix on top of the
burner rails.
2. Next, remove the front coal strips from the
protective packaging and position as shown.
The rear edge of the front coal strips should fit
in front of the burner rail. Again, do not to
place on top of the burner rails. When the front
coal strips are in position bend up the three
metal tags at the front of the tray to retain
(inset).
8
11.2
12.0
Correct
Incorrect
