EKO PV Blocks MP-1000S, Инструкция по эксплуатации

Страница: 43 / 64

PV Blocks system Page 43
Reset base unit
When the system is malfunctioning, this button can be used to reset the hardware. After
the pressing this button wait for one minute before enabling the scheduler.
Scan PVBlocks
This will perform a hardware scan to get all the connected PVBlocks. This is required
when something changes in the system (adding or removing PVBlocks).
Send trigger
This will send a measurement trigger to all PVBlocks. Please do not use this, it is there
for service only.
Direct control
This will allow for the direct control of all PVBlocks. Please do not use this, it is there for
service only.
On the right an overview of the installed PVBlocks is shown.
There are 4 columns:
Position
This is an optional parameter that can be set to indicate the physical location of a
PVBlock in the system.
As the system is unaware of the physical location of a PVBlock in the system, the
user has the indicate the position manually. This is optional, but will make it easier to lo-
cate a certain PVBlock.