Chapter 9 Reference
9-1. Attaching the Installation Fixture
This product can be detached from the stand and attached to an installation fixture.
Attention
•
When installing, do so by carefully following the information in the User Manual about the arm or stand.
•
Ensure the following and select components that comply with the VESA standards.
- Clearance between screw holes: 200 mm x 200 mm
- Must be strong enough to support weight of the monitor unit and attachments such as cables.
•
Please follow the specifications for the screw tightening torque. If the tightening is not performed correctly, the
attached part may be damaged, which may result in injury or equipment damage.
•
Do not install the display screen at an angle. Position it vertically.
•
Connect the cables after attaching an arm or stand
•
Installation should be performed by two or more people.
•
The monitor and installation fixture are heavy. Dropping them may result in injury or equipment damage.
•
Periodically check the tightness of the screws. If not sufficiently tight, the monitor may detach from the arm, which
may result in injury or equipment damage.
1.
Being careful not to damage the LCD panel surface, and being careful not to
put weight on the parts of the monitor that stick out (the built-in calibration
sensor and the dial), place the LCD panel surface face-down on a table or
other stable location.
2.
Remove the stand.
Remove the fixing screws on the stand, and detach the left and right sides of the stand.
62
Chapter 9 Reference
