Eighteeth E-connect S, Руководство пользователя

Страница: 20 / 47

6 Setting
Auto Return time
5
Se c
Press S again, the “Auto Return time” can be
change, it means when setting parameters just like
speed and torque, the system will back to standby
interface if there is no operation in 5 seconds.
press
< or > to adjust, then press
●
to
confirm.
The “Auto Return time” can be set from 3-15 seconds.
Bee pe r Vol um e
V ol .
2
Press S again, the “Beeper Volume” can be change,
press < or > to adjust, then press
●
to
confirm.
The “Beeper Volume” can be set from 0-3.
Hab it h and
Right Hand
Press S again, the “Habit hand” can be change,
press < or > to adjust, then press
●
to
confirm.
The right hand and the left hand can be set.
Startup memory
M1
Press S again, the “Start memory” can be change, it
means every time turn power on, which memory mode
will appear first.
press
< or > to adjust, then press
●
to
confirm.
M1 and Last (the memory mode number when you turn
power of ) can be set.
Cal ib rat io n
OFF
Press S again, entry “Calibration” function, press <
or > to select “ON”, press
●
to start calibration.
WARNING
●
Before calibrating, making sure the original contra
angle is installed, and do not install the file.
●
The torque will not correct if calibration without
original contra angle or any load on contra angle chuck,
and has risk of file broken.
Calibration
1000
r p m
The motor speed will increase from 120 to 1000 rpm.
When the speed up to 1000 rpm, the calibration
successful and automatic power off.
Page 20 / 47