Egholm City Ranger 2260, Руководство оператора

Страница: 59 / 72

59
1
2
3
Operator’s Manual City Ranger 2260 Operator’s Manual City Ranger 2260
Jacking point, rear wheel
Jacking point, front wheel
3.11 Generator V-belt
Adjustment and tightening
A loose V-belt can result in insufficient charging of
the battery.
1. Check the V-belt by pressing the middle section
with a finger to see if there is approx. 7–9 mm slack
(about 10 kg of pressure).
2. Check the V-belt for wear and tear.
Tightening
Loosen the two bolts that hold the generator, then
adjust/tighten them until the V-belt is at the required
tension. Remember to tighten the bolts and nuts
after adjusting! (Picture 3)
3.12 Removal of wheels
Before removing a wheel, the engine must be
stopped and the parking brake activated.
Loosen the wheel nuts before the wheel is lifted off
the ground.
Jacking point:
• for the rear wheel. (Picture 1)
• for the front wheel. (Picture 2)
When fitting the wheels, tighten the wheel nuts to
100Nm after the machine is lowered to the ground.
Attention
After 20 hours of use, tighten the wheel
bolts again to 100 Nm. Wheel bolts
should not be lubricated.
Attention
Only use tyre dimension and tyre
pressure as specified in section 1.4 page
10.
Attention
Changing tyres on rims may only be
carried out at an authorized workshop.
Service and maintenance
Loosen the two bolts
Tightening the V-belt