Edwards iXM Series, Инструкция по эксплуатации

Страница: 46 / 104

Figure 16 Protective Earth (PE) connection
Electrical connector locking mechanism
This product is approved permanently connected equipment and must be used as
described below:
The pumping system has an electrical connector locking mechanism (
Figure: Controls/
connectors on the rear of the system ). Use an applicable screwdriver to release.
The pumping system is supplied with a protective cover ( Figure: Electrical connector
locking mechanism ) installed and the locking mechanism can be applied. Use the
following instructions to install the electrical supply cable.
▪ Turn the locking screws to loosen the locking mechanism, if necessary.
▪ Move the locking mechanism as far as possible to the left.
▪ Push up the lever to release the protective cover.
▪ Remove the protective cover and attach the electrical supply cable.
▪ Pull the lever downwards to lock the electrical supply cable connector in place.
▪ Push the locking mechanism as far as possible to the right so that it prevents the
lever from functioning.
▪ Tighten the locking screws to firmly hold the locking mechanism in place.
▪ Connect the other end of the electrical supply cable to the electrical supply
through an isolator.
10/2020 - ©Edwards Limited Page 43 M56635880_D
M56635880_D - Installation