EDWARDS SYSTEMS TECHNOLOGY EST2, Инструкция по установке

Страница: 77 / 120

P/N: 387132 REV: 4.0 Page 3 of 4
Entering the programming mode
Connect the phone to J3.
When the Status LED
turns solid green, press
4727 (GSBS) on the
telephone keypad. Listen for the confirmation
tone to verify that the dialer
has accepted the password. The status LED will display
a steady green LED to
indicate that the dialer is
ready for programming.
Take the handset off the
hook. The status LED will display two
rapid green flashes, and then
turn solid green.
DIALER PROGRAMMING
- Continued -
Entering the password
Entering the dialer data
Note: Enter the required information for all 8 programming items in sequence.
1 A confirmation tone indicates the correct entry of a program item.
2 Phone lines must be loop start on a public-switched network. PBX, party lines, and ground start lines are not acceptable.
3 The dialer does not place calls, monitor the panel, or monitor the phone lines during the programming process.
4 After initial programming, the dialer notifies the central monitoring station that it is disabled before programming can proceed.
5 Two phone lines are required to comply with NFPA 72.
6 The dialer will automatically switch to pulse dialing after three consecutive failures using tone mode. It will switch back to tone dialing after
failing to connect using pulse mode, upon re-programming, or upon enabling disconnect switch.
J3
J2
J1
Before programming can
proceed, the dialer will notify
the CMS for any previously
entered numbers. The status
LED will display a slow green
flash during the dialing process.
Notes
1 2 3
1 2 4 3
Listen for the confirmation
tone to verify that you
entered 01.
Listen for the confirmation
tone to verify that you
entered 03.
Listen for the confirmation
tone to verify that you
entered 02.
Listen for the confirmation
tone to verify that you
entered 04.
Make sure that the status LED
displays a steady green pattern
interrupted by amber flashes.
Make sure that the status LED
displays a steady green pattern
interrupted by double amber
flashes.
Make sure that the status LED
displays a steady red pattern
interrupted by amber flashes.
Make sure that the status LED
displays a steady red pattern
interrupted by double amber
flashes.
Programming the primary site ID number (item 01)
Programming the secondary site ID number (item 03)
Programming the primary CMS number (item 02)
Programming the secondary CMS number (item 04)
Enter the 4-digit ID number
on the telephone keypad.
Use leading zeroes as
required.
Enter the 4-digit ID number
on the telephone keypad.
Use leading zeroes as
required.
Enter a 7 to 24-digit number
on the telephone keypad to
specify the primary CMS
number.
Enter a 7 to 24-digit number
on the telephone keypad to
specify the secondary CMS
number.
Press the following telephone keys:
0
1
*
Press the following telephone keys:
0
3
*
Press the following telephone keys:
0
2
*
Press the following telephone keys:
0
4
*
1 2 4 3
1 2 4 3
1 2 4 3
1 2 4 3
Technical Manuals Online! - http://www.tech-man.com
firealarmresources.com