EDWARDS SYSTEMS TECHNOLOGY EST2, Инструкция по установке

Страница: 106 / 120

P/N: 387208 REV: 2.0 Page 2 of 2
S1
Group number Output addresses S1 dip switch settings Module
1 2 3 4
1 01-08 on off off off 2-SANCOM
2 09-16 off on off off SHO-4
3 17-24 on on off off SDR-32(K)
4 25-32 off off on off SDR-32(K)
5 33-40 on off on off SDR-32(K)
6 41-48 off on on off SDR-32(K)
7 49-56 on on on off
8 57-64 off off off on
9 65-72 on off off on
10 73-80 off on off on
11 81-88 on on off on
12 89-96 off off on on
ON 1 2 3 4
To set the dip switches:
A. Configure the SAN-CPU in the system programming utility.
B. Note the in the programming utility
(09 to 65).
C. Set the dip switches on S1 to the group number of the
SDR-32(K)’s start output address.
start output address of the SDR-32(K)
Set the SDR-32(K) dip switches. 3
Remember that the SDR-32(K):
Cannot occupy the 2-SANCOM addresses (01 through 09).
Requires four output address groups, which consist of eight
addresses each.
INSTALLATION
FIELD WIRING
In this example,
start
address is 17 and
the dip switches are
set to a binary 3.
the
SIN-16 does not
require any output
addresses. The
SDR-32(K)
S1
SDR-32(K)
1
17
9
25
P01
SDR-32(K)
P03
P02
P04
8
24
16
32
External device
power supply External device
power supply
+ +
_ _
SDR-32K EXR
relay connection
SDR32K Auxiliary
relay connection
Resistor value to be sized for 100 mA
maximum current per output
To SAN-CPU
24 Vdc power in (-) terminal
All wiring is power-limited.
Nonsupervised connection
Connect the
power supply to the SAN-CPU
power input
terminal.
(-) terminal of the external device
(-)
SDR-32K LED connections
SDR-32 LED connections
Notes
1
2
2
2
3
3
!
Cautions
Observe static-sensitive material handling
practices.
Use some current limiting for the incandescent
lamps. Momentary current surges can exceed the
100 mA rating on the switching transistor and cause
permanent damage.
Make the ribbon cable connections. 2
JP1
P1 P1 P1
P1
P2 P2 P2
P2
2-SANCOM
From P1
on the
SAN-CPU
SIN-16
SDR-32(K)
SHO-4
A. Plug the ribbon cable assembly (P/N 250080) from P1 of the SAN-CPU into P2 of the 2-SANCOM.
B. Plug the ribbon cable from P1 of the 2-SANCOM to P2 of the next SAN series module.
C. Plug the ribbon cable from P1 of each SAN module to P2 of the next SAN module until you reach the last one.
D. Install the continuity jumper on the last SAN module.
Note: If the SDR-32(K)
is the last module,
install the continuity
jumper on JP1.
Technical Manuals Online! - http://www.tech-man.com
firealarmresources.com