Edgewater Networks 318CC, Руководство для владельца

Страница: 201 / 213

14 Pro-Series & Pro-Fish Windlass 15 Pro-Series & Pro-Fish Windlass
GB
8. Lewmar limited warranty
LIMITED WARRANTY and
KEY TERMS OF SUPPLY BY LEWMAR
Lewmar warrants that in normal usage and with proper maintenance its
products will conform with their specifi cation for a period of fi ve years
from the date of purchase by the end user, subject to the conditions,
limitations and exceptions listed below. Any product, which proves to be
defective in normal usage during that fi ve-year period, will be repaired
or, at Lewmar’s option, replaced by Lewmar.
A CONDITIONS AND LIMITATIONS
i Lewmar’s liability shall be limited to the repair or replacement
of any parts of the product which are defective in materials or
workmanship.
ii Responsibility for the selection of products appropriate for the use
intended by the Buyer shall rest solely with the Buyer and Lewmar
accepts no responsibility for any such selection.
iii Lewmar shall not be liable in any way for Product failure, or any
resulting loss or damage which arises from:
a use of a product in an application for which it was not designed or
intended;
b. corrosion, ultra violet degradation or wear and tear;
c. a failure to ser vice or maintain the product in accordance with
Lewmar’s recommendations;
d. faulty or defi cient installation of the product (unless conducted by
Lewmar);
e. any modifi cation or alteration of the product;
f. conditions that exceed the product’s performance specifi cations or
safe working loads.
iv Product subject to a warranty claim must be returned to the Lewmar
outlet which supplied the product for examination unless otherwise
agreed by Lewmar in writing.
v This warranty does not cover any incidental costs incurred for the
investigation, removal, carriage, transport or installation of product.
vi Service by anyone other than authorised Lewmar representatives
shall void this warranty unless it accords with Lewmar guidelines
and standards of workmanship.
vii Lewmar’s products are intended for use only in the marine
environment. Buyers intending to use them for any other purpose
should seek independent professional advice as to their suitability.
Lewmar accepts no liability arising from such other use.
B EXCEPTIONS
Cover under this Warranty is limited to a period of one year from the date
of purchase by the end user in the case of any of the following products
or parts of products:
• Electric motors and associated electrical equipment
• Electronic
controls
• Hydraulic pumps, valves and actuators
• Weather seals
• Products used in “Grand Prix” racing applications
C LIABILITY
i Lewmar’s liability under this warranty shall be to the exclusion of
all other warranties or liabilities (to the extent permitted by law). In
particular (but without limitation):
a Lewmar shall not be liable for:
• Any loss of anticipated turnover or profi t or indirect, consequential
or economic loss ;
• Damages, costs or expenses payable to any third party;
• Any
damage to yachts or equipment;
• Death or personal Injury (unless caused by Lewmar’s negligence).
Some states and countries do not allow the exclusion or limitation of
incidental or consequential damages, so the above limitation or exclusion
may not apply to you.
b Lewmar grants no other warranties regarding the fi tness for purpose,
use, nature or satisfactory quality of the products.
ii Where applicable law does not permit a statutory or implied warranty
to be excluded, then such warranty, if permitted by that state or
country’s law, shall be limited to a period of one year from the date
of purchase by the end user. Some states and countries do not allow
limitations on how long an implied warranty lasts, so this limitation
may not apply to you.
D PROCEDURE
Notice of a claim for service under this warranty shall be made promptly
and in writing by the end user to the Lewmar outlet which supplied the
product or to Lewmar at Southmoor Lane, Havant, Hampshire, England
PO9 1JJ.
E SEVERANCE CLAUSE
If any clause of this warranty is held by any court or other competent
authority to be invalid or unenforceable in whole or in part, the validity
of the remaining clauses of this warranty and the remainder of the clause
in question shall not be affected.
F OTHER RIGHTS
This warranty gives you specifi c legal rights, and you may also have other
legal rights, which vary, from state to state and country to country.
In the case of European States a Consumer customer (as defined
nationally) has legal rights under the applicable national law governing
the sale of Consumer Goods; this Warranty does not affect those
rights.
G LAW
This warranty shall be governed by and read in accordance with the laws
of England or the state or country in which the fi rst end user is domiciled
at the time of purchase of the product.
H DISPUTES
Any dispute arising under this warranty may, at the option of the end-user,
be referred to alternative dispute resolution under the rules of the British
Marine Federation or to the Courts of the State whose law shall govern
the warranty or to the Courts of England and Wales.
The British Marine Federation may be contacted at Marine House,
Thorpe Lea Road, Egham, England, TW20 8BF
7. Troubleshooting
7.1 Anchor rode pays out independently
while windlass is not in use
This problem is a result of not securing the anchor rode combined
with the Clutch Nut (1) being slack. Tighten the clutch nut
using the tool provided and always secure the anchor rode
independently of the windlass whenever it is not being deployed
or recovered.
7.2 Anchor rode pays out independently
while windlass not in use (Pro-Fish)
This problem is a result of not securing the anchor rode combined
with the internal Clutch mechanism not being fully engaged.
Operate the UP button briefl y to fully re-engage the internal
Failure to Operate (Pro-Series 700 Only) Troubleshoot Chart: Reversing Toggle Control Switch (Part No. 0052519)
Is there voltage at the input terminal (positive) to the control
switch?
If no voltage is present, the battery isolation switch is OFF, the
breaker is tripped or a fuse has blown. The battery may also
have been dead or disconnected.
YES NO
Check voltage at the output terminals of the control switch
with the switch on forward then reverse.
Is there voltage at either output terminal for forward then
reverse.?
Control switch is defective.
YES NO
Replace motor.
Sluggish Operation Troubleshoot Chart
Is windlass overloaded?
Ease the load and ensure the battery is well charged.
YES NO
Check the voltage across the motor leads with the windlass
on. (Proper voltage is 13.5 V. Constant low voltage will destroy
the motor).
Is the voltage low? (Below 11.0 V on a 12 V system).
There is a severe voltage drop in the circuit.
Check for undersized cables, poor connections or corroded
connections. Also check for resistance across the batter y
isolation switch or solenoid. (Feel them to see if they are
heating up).
YES NO
Is the voltage correct? (Above 11.0 V and anchor is not
fouled).
The motor is defective. Replace the motor.
YES
Failure to Operate Troubleshoot Chart
Is there voltage at the input terminals to the contactor and
switch(es)?
Check the circuit breaker/isolator switch and any fuses.
YES NO
Operate the switch. Is there voltage at the positive switch terminal
on the solenoid?
The switch (or its wiring), is defective.
YES NO
Keep the switch activated. Is there voltage at the main output
terminal on the contactor?
Check the contactor coil ground circuit. If okay, replace the
contactor.
YES NO
Check the voltage at the motor. If voltage is present, the motor
is defective. If you have any questions call your nearest Lewmar
representative.
clutch mechanism. Always secure the anchor rode independently
of the windlass whenever it is not being deployed or recovered.
7.3 Electrical troubleshooting
As with most electrical marine equipment the majority of problems
that arise are electrical in nature. Therefore it is essential that
the proper voltage be maintained. The proper voltage on a 12
volt system is 13.5 volts. (Constant low voltage will destroy the
motor). Ensure that electrical cable size is large enough to handle
the current draw imposed upon it and to keep the voltage drop
within acceptable limits. In any circumstance voltage drop due
entirely to cable resistance should not exceed 10%.
Follow the charts to troubleshoot the problem.